Ball Burnishing as Finish Method of Compressor Shaft Wear Sleeve
2013
Guntis Pikurs, Guntis Bunga, Viktors Gutakovskis, Artis Kromanis

Nowadays more and more advanced technologies in surface finish are developed. The ball burnishing technology of wear sleeve gives smoothened surface characteristics, which im-proves initial abrasive wear resistance, bearing rate, and residual compressive stresses in the surface layer of the wear sleeve. These parameters may significantly increase the life cycle of PTFE seal-ing knot. This paper recognizes the technology advances in wear sleeve manufacturing and gives directions for further research and discussion.


Atslēgas vārdi
ball burnishing, wear sleeve, PTFE seal.

Pikurs, G., Bunga, G., Gutakovskis, V., Kromanis, A. Ball Burnishing as Finish Method of Compressor Shaft Wear Sleeve. Ražošanas tehnoloģija. Nr.35, 2013, 34.-37.lpp. ISSN 1407-8015. e-ISSN 2255-8721.

Publikācijas valoda
English (en)
RTU Zinātniskā bibliotēka.
E-pasts: uzzinas@rtu.lv; Tālr: +371 28399196