Determining the Thermal Conductivity of Additively Manufactured Metal Specimens
2022 29th International Workshop on Electric Drives: Advances in Power Electronics for Electric Drives (IWED 2022) 2022
Martin Sarap, Ants Kallaste, Payam Shams Ghahfarokhi, Hans Tiismus, Toomas Vaimann

This paper presents a method for experimentally determining the thermal conductivity of additively manufactured specimens. Selective laser melting was used to fabricate two metal rods – one from an aluminum alloy (AlSi10Mg) and the other from silicon steel (Fe-3.7%w.t.Si) powder. For measuring the thermal conductivity, an experimental setup is designed and the measurements are carried out. According to the experimental results, the thermal conductivities of the aluminum and steel rods are 107.8±3.95 and 25.97 ± 0.86W /m/K respectively.


Atslēgas vārdi
Thermal conductivity, three-dimensional printing, electric machines
DOI
10.1109/IWED54598.2022.9722591
Hipersaite
https://ieeexplore.ieee.org/document/9722591

Sarap, M., Kallaste, A., Shams Ghahfarokhi, P., Tiismus, H., Vaimann, T. Determining the Thermal Conductivity of Additively Manufactured Metal Specimens. No: 2022 29th International Workshop on Electric Drives: Advances in Power Electronics for Electric Drives (IWED 2022), Krievija, Moscow, 26.-29. janvāris, 2022. Piscataway: IEEE, 2022, 1.-4.lpp. ISBN 978-1-6654-6787-2. e-ISBN 978-1-6654-6786-5. ISSN 2767-7834. e-ISSN 2767-7842. Pieejams: doi:10.1109/IWED54598.2022.9722591

Publikācijas valoda
English (en)
RTU Zinātniskā bibliotēka.
E-pasts: uzzinas@rtu.lv; Tālr: +371 28399196